Buy Cheap SOUND PROFESSIONALS – PLUG-IN PREAMP FOR PROFESSIONAL MICS 
Buy Low Price From Here Now
SOUND PROFESSIONALS – PLUG-IN PREAMP FOR PROFESSIONAL MICS (MICROPHONE SHOWN IN PICTURE NOT INCLUDED). MADE IN USA.
Plug-in preamp for use with Professional XLR microphones and small mics. Finally, a great sounding, low noise, high quality preamp that runs on a battery! This preamp will give you professional quality amplification for your microphone. Other similar preamps available (sometimes for under $50) offer similar amplification, but not with this low level of noise and distortion. When looking for a mic preamp, it’s important to look closely at the frequency response, noise and distortion specifications. If you don’t see them, there is usually a good reason! Previously, preamps of this quality cost several hundred dollars – now, you can get professional quality for much less!
* 0dB gain for recording loud sounds (loud rock concerts, etc) * 29dB gain for recording moderately loud sounds (acoustic music, lectures, meetings, rehearsals, etc) * 50dB gain for recording extremely quiet sounds (nature sounds, distant talking, soft spoken people, etc) * Runs 75+ hours on a single 9 volt battery * Output cable: 48″ gold plated 1/8″ (3.5mm) stereo mini plug * Input connector: Neutrik Mono XLR Female connector and 1/8″ (3.5mm) stereo mini jack with 9vdc plug-in-power (plugging microphones into mini jack blends stereo signal with XLR connector on left channel) * Signal to noise ratio: 115 dBu EIN unweighted * Harmonic distortion: 0.06% * 106dB dynamic range * Frequency response 20 to 20khz +/- 1dB * EMI input protection * High output drive-capable of providing 1.5V RMS into a 10K load * Built-in 9 volt “plug-in-power”-no additional battery module needed to power your mini microphones! * Compatible with all MiniDisc, DAT, MP3, VHS, Camcorder and Cassette recorders with line inputs * Battery reverse-polarity protection * Includes output level control * Belt clip and battery included *…….
Readmore
Technical Details
– Change a standard mic into “preamplified mic” for use with recorders that have no mic input!
– Plugs right into the base of professional microphones with XLR connectors
– Used to raise high or low impedance microphone signal level to line level
– Dimensions: 1″ X 2.4″ X 3″ not including controls and connectors
– 3 Gain ranges for maximum flexibility
See more technical details (continue reading…)








